need some help please Duet 2 Wifi BL touch Ender 3
-
@Stephen6309 im sorry but what exactly do you mean. I have them in the first screenshot it shows
; Endstops
M574 X1 Y2 S1 ; X home to min. Y home to max. Normally Closed limit switches.
M574 Z1 S2 ; Define Z to use Probe. Home to Min -
@Zayy said in need some help please Duet 2 Wifi BL touch Ender 3:
M574 X1 Y2 S1 ;
that is the rrf2 config, you need to switch to rrf3 config
-
@Zayy said in need some help please Duet 2 Wifi BL touch Ender 3:
do you have a discord I could get in contact via a call with you
we want the information available for everyone. the forum is a important part of the community info.
if we move to discord this dissipaters. -
@Zayy For 3.0 to 3.2rc2, endstops need the pin.
My defines:
; Endstops
M574 X1 S1 P"121.io1.in" ; configure active-high endstop for low end on X via pin 1.io1.in
M574 Y1 S1 P"io2.in" ; configure active-high endstop for low end on Y via pin io2.in
M574 Z1 S2 ; configure Z-probe endstop for low end on Z; Z-Probe
M950 S0 C"121.io0.out" ; create servo pin 0 for BLTouch
M558 P9 C"^121.io0.in" H10 F120 T6000 ;A2 ; set Z probe type to bltouch and the dive height + speeds
G31 P500 X-11 Y-50 Z0 ; set Z probe trigger value, offset and trigger height
M557 X10:400 Y10:300 S30 ; define mesh grid -
@Stephen6309 should i copy what you have because i honestly do not know what it should say and im lost. sorry i feel bad for not knowing but i basically have a $400 metal brick on my desk at this point
-
@Veti i do not even know what rrf2 config please elaborate
-
its the firmware version you selected in the first step.
the config you posted is for version 2
in the screenshot you posted of the configurator, you selected version 3
the config version needs to match the installed version
-
-
so post your new config.g and homing and retract and deploy scripts.
-
still showing up as "M574 X1 Y2 S1"
-
this is not the config that the online configurator with version 3 produces. you need to replace your existing config with the new ones.
-
@Veti someone went through and helped me reconfig the whole thing thank you for the help.