Temp hotend not stop other limit and have error
-
@stefano said in Temp hotend not stop other limit and have error:
; Memorizza
M500
; Leggi Parametri
M501this is bad there should be no M500 in config.g
-
@Veti remove M500
-
now you need to pid tune again, because that has deleted the results of the pid tune
-
@Veti new auto tune ok. If not solve write
-
4/2/2021, 18:30:14 Warning: Auto tune of heater 1 failed due to bad curve fit (A=1970.5, C=166.0, D=5.6)
4/2/2021, 18:27:40 Auto tune phase 3, peak temperature was 325.5
4/2/2021, 18:27:30 Auto tune phase 2, heater off
4/2/2021, 18:27:00 Auto tune phase 1, heater on
4/2/2021, 18:26:54 M303 H1 S280
Auto tuning heater 1 using target temperature 280.0°C and PWM 0.80 - do not leave printer unattended -
@stefano said in Temp hotend not stop other limit and have error:
M305 P1 T100000 B4138
What thermistor do you have? These values may not be correct for your thermistor.
If you're unsure, try changing B4138 to B3950.
-
have thermistore HE3D
-
Based on a quick google it looks like B3950 should work better.
-
tomorrow change value and tell if have solve, have list with all code thermistore? have gcode for test thermistore o for see correct number
-
@Phaedrux said in Temp hotend not stop other limit and have error:
B3950
Have this error Warning: Auto tune of heater 1 failed due to bad curve fit (A=1636.8, C=129.8, D=6.1)
-
With that overshoot in temperature I have to wonder if it's a problem with using a 12volt heater cartridge on a 24volt system.
-
Can you please measure the resistance of the heater cartridge?
Are you sure the heater is 24v?
