PID Hotend Autotune - How Long?
-
@Adamfilip said in PID Hotend Autotune - How Long?:
M303 H1 S220 A
the command in 3.2 for tools is M303 T0 S220 it tests with fan and without
-
Does it matter what idle temp the hotend is before you start this?
-
Ok so Ive restarted, Run M303 T0 S220
1Hr and 15min into it..
last message from Console is
Auto tune starting phase 3, fan ontemp is around 218.4
-
When I send a M303 it says
Heater 1 is being tuned, phase 5 of 5
-
its not finished
-
So it takes hours?
-
@Adamfilip said in PID Hotend Autotune - How Long?:
So it takes hours?
look at the temperature graph it should go up and down
-
Looks solid.
-
Board: Duet 2 WiFi (2WiFi)
Firmware: RepRapFirmware for Duet 2 WiFi/Ethernet 3.2 (2021-01-05)
Duet WiFi Server Version: 1.25 -
; Heaters M308 S0 P"bedtemp" Y"thermistor" T100000 B4138 ; configure sensor 0 as thermistor on pin bedtemp M950 H0 C"bedheat" T0 ; create bed heater output on bedheat and map it to sensor 0 M140 H0 ; Map heated bed to heater 0 M143 H0 S120 ; set temperature limit for heater 0 to 120C M307 H0 A61.9 C160.5 D1.3 B0 S0.5 v24.4 ; disable bang-bang mode for the nozzle heater and set PWM limit M308 S1 P"e0temp" Y"thermistor" T100000 B4725 C7.06e-8 ; configure sensor 1 as thermistor on pin e0temp M950 H1 C"e0heat" T1 ; create nozzle heater output on e0heat and map it to sensor 1 M143 H1 S285; set temperature limit for heater 1 to 280C M307 H1 A310.2 C150.5 D3.5 B0 S1 v24.3 ;NEW
-
that may be one for @dc42
-
Tried again,
Fine until it reaches Phase 3 with Fan on,
Fan is working at 100% but temp does not cycle -
Photo of your hotend? It may be expecting to see a drop from the fan, but it's not happening.
-
@Adamfilip said in PID Hotend Autotune - How Long?:
Does it matter what idle temp the hotend is before you start this?
It should be from ambient.
-
-
My Cooling is excessive when turned onto full, that's why I'm doing to Autotune as I had a 15 degree drop and It faulted during my last print
-
Are you controlling the fan yourself during the tune with M303 T0?
You should leave the fan off and the firmware will turn it on when needed.
-
I not manually controlling it. it was set to off and nozzle temp was ambient last time I tried (running now.. 1.5hrs in so far)
-
You're tuning to 220 and it's steady at 218. Try tuning to 215.
-
ok will attempt