Ender 3 pro Bl Touch
-
@HudsonCap what 'adjustments' are you trying to make?
Simple z probe to determine z=0?
Auto bed levelling/traming?
Bed mesh compensation?
All three? (Guessing that's where you're aiming?)Where have you got to and what is not working? Post your relevant config, homing and bed files.
-
@engikeneer I realy sorry im am new to 3d printing and i cant understand want you want me to do.
-
Ok after doing some research I Figured out what you mean the z offset is not the problem due to the fact that the printer acts like the BL touch is not there its the exact same if i didnt have it the bl touch works fine but dost seem to efect any thing.
-
Copy and paste the contents of config.g, homeall.g, and homez.g into a post so we can see what it's trying to do.
Also send M122 in the gcode console and copy and paste the results please.
Also, here's a guide that goes through adding a BLTouch that might help.
https://duet3d.dozuki.com/Guide/Ender+3+Pro+and+Duet+Maestro+Guide+Part+5:+Upgrades/54#s220
-
how do i find the contents of config.g and the others?
-
If you're connected to the web interface you can get to those files in the system tab on the left side.
https://duet3d.dozuki.com/Wiki/Duet_Web_Control_v2_and_v3_(DWC)_Manual#Section_System
Are you actually using a Duet?
-
i am not connected to the printer except for octoprint will this work
-
Well, no. This is a forum mainly for Duet3D control boards running RepRapFirmware.
Are you running a stock Ender 3 Pro with the electronics that came with it? Plus Octoprint, apparently?
-
you are correct im run stock
-
Maybe this will be more helpful: https://www.youtube.com/watch?v=ocAeZRPVusw&ab_channel=TeachingTech
-
ok thank you i will try
