lost wifi after print
-
hi
since update to 3.3 beta1 my duet lost connection wifi afer print,
i testing, in my finish print macro the command gcode M552 S-1 and M552 S1,a rescue solution -
Please try sending M997 S1 via USB terminal or PanelDue console to reflash the wifi module and when it's done reboot.
-
@bastien said in lost wifi after print:
hi
since update to 3.3 beta1 my duet lost connection wifi afer print,
i testing, in my finish print macro the command gcode M552 S-1 and M552 S1,a rescue solutionDuet WiFi, or Duet 3 Mini5+?
Which version of the WiFi server firmware is installed? If the WiFi has been enabled then M122 will give the version number in the WiFi section of the report.
-
RepRapFirmware for Duet 2 WiFi/Ethernet version 3.3beta1 running on Duet WiFi 1.02 or later
WiFi firmware version 1.23 -
@bastien said in lost wifi after print:
WiFi firmware version 1.23
That means it did not update along with the other firmware.
https://github.com/Duet3D/RepRapFirmware/releases/download/3.2/DuetWiFiServer.bin
Download that bin file and place it in the /sys folder of the SD card.
Then send M997 S1 in the USB terminal to flash the wifi firmware.
Then check M122 again to see if it's now at 1.25.
-
thanks i test tomorrow
-
It's ok, thanks
-
3.2.2 here, I can confirm I also got stuck with wifi at 1.23, and running the command M997 S1 two times started the flashing properly.
Now I got 1.25... found the answer here.
