lost wifi after print

[bastien]

hi
since update to 3.3 beta1 my duet lost connection wifi afer print,
i testing, in my finish print macro the command gcode M552 S-1 and M552 S1,a rescue solution

[Phaedrux]

Please try sending M997 S1 via USB terminal or PanelDue console to reflash the wifi module and when it's done reboot.

[dc42]

@bastien said in lost wifi after print:

hi
since update to 3.3 beta1 my duet lost connection wifi afer print,
i testing, in my finish print macro the command gcode M552 S-1 and M552 S1,a rescue solution

Duet WiFi, or Duet 3 Mini5+?

Which version of the WiFi server firmware is installed? If the WiFi has been enabled then M122 will give the version number in the WiFi section of the report.

[bastien]

RepRapFirmware for Duet 2 WiFi/Ethernet version 3.3beta1 running on Duet WiFi 1.02 or later
WiFi firmware version 1.23

[Phaedrux]

@bastien said in lost wifi after print:

WiFi firmware version 1.23

That means it did not update along with the other firmware.

https://github.com/Duet3D/RepRapFirmware/releases/download/3.2/DuetWiFiServer.bin

Download that bin file and place it in the /sys folder of the SD card.

Then send M997 S1 in the USB terminal to flash the wifi firmware.

Then check M122 again to see if it's now at 1.25.

[bastien]

thanks i test tomorrow

[bastien]

It's ok, thanks

[manpowre]

3.2.2 here, I can confirm I also got stuck with wifi at 1.23, and running the command M997 S1 two times started the flashing properly.

Now I got 1.25... found the answer here.