VIN under-voltage event only after M84

Poent

For the power supply, I'm only as confident as the sticker on the side. I do have a multimeter and have used that to ensure that I'm getting 12v from the supply. I have not yet measured the voltage coming from the supply when the issue is occurring however - I will see if I can capture that.

The PSU is powering the Duet board, 3x Nema17 motors, one small fan, and a large heated bed (though the heated bed has been disabled/off for all of my testing).

I'm not sure the best way to test if anything is getting hot on the duet board, but gently touching the drives and what I think is the voltage regulator, they do not seem to be producing a concerning amount of heat.

alankilian

You can try editing your config.g and only defining one axis, no hot-end, no bed heater and try again.

Then configure two, three etc and see if it comes back.

I had a power-supply that held 12 Volts just fine most of the time, but would drop to 10 Volts under even a light load.

So I replaced it and everything was fine.

Poent

@SIam

I just had a moment to test with the multi-meter and when replicating the issue VIN measures at 10.49v. VIN through the Duet Web GUI reads 9.5v. Confirming the Low-Voltage reading.

alankilian

It sounds like your power supply has failed to maintain its voltage under a small load.

It happened to me and I needed to replace the power supply.

Phaedrux

Can you provide a M122 before and after that error message?

Poent

Sure thing.

Here are the results from each:

M112_Before.txt
M112_After.txt

The specific steps I took to replicate the above were:

restart the Duet
Home all Axis (worked normally without issue)
send M84
Home all axis (Undervoltage error, steppers begin skipping repeatedly until endstops are hit (5mm away, skipped steps take a long time to hit endstops).
M84 is sent again to stop skipping steps (can hear the steppers skipping while holding idle until m84 is sent again).

dc42

If it's a PC power supply (e.g. ATX), these have minimum load requirements. If the load is too low then on the cheaper power supplied especially, the output voltage may rise too high and the over-voltage protection will cut in.

Poent

@dc42

I'm currently using a dedicated 12v 30a switching power supply, though it is certainly a cheap Amazon supply and wouldn't be surprised if it's failing.

Is there a power supply you recommend? I've already ordered a replacement 24v switching power supply to test with, but would be interested to know your recommendations.

Thanks

edit: I've found the "choosing a power supply link" in the wiki, so nevermind!
https://duet3d.dozuki.com/Wiki/Choosing_the_power_supply

Poent

Replaced the power supply and the issue was instantly resolved.

Nothing more than an odd coincidence with the rebuild!

alankilian

Awesome!