Extruder disappeared from DWC

[Sytac072]

Hello, I have an issue...
I own a duet2 wifi and yesterday I tried to upgrade from RRF 3.2.2 to RRF 3.3 b3 and at this point, the extruder disappeared from the DWC 3.3 b3 as well as from the paneldue.

config.g

Any idea?

[droftarts]

@sytac072 I think it might be the F-1 in your M563 tool definition, causing the tool not to be defined. It’s not needed. Not sure why this works in 3.2.2 and not in 3.3b3. Send M98 P”config.g” first, which will run config.g and show if there are any errors.

Ian

[Sytac072]

@droftarts Thank you very much for your quick reply and tip. This was the issue. I removed the F-1 and the extruder came back.