I am near.... but

[peirof]

Hi,

with the help of forum Staff and members, i am close to finish migration from FW 2.x to FW 3.4

one of the last things I am missing is the extruder, nothing appears in the DWC ...

I have these lines in the config.g. What am I missing? What have I overlooked?

;Extruder
M308 S1 P"e0temp" Y"thermistor" T100000 B4138  ; configure sensor 1 as thermistor on pin e0temp
M950 H1 C"e0heat" T1                           ; create nozzle heater output on e0heat and map it to sensor 1
M307 H1 B0 S1.00                               ; disable bang-bang mode for heater  and set PWM limit
M143 H1 S280                                   ; set temperature limit for heater 1 to 280C
M143 H1 S280                                   ; set temperature limit for heater 1 to 280C


; Tools
M563 P0 D0 H1									; Define tool 0
G10 P0 X0 Y0 Z0 								; Set tool 0 axis offsets
G10 P0 R0 S0 									; Set initial tool 0 active and standby temperatures to 0C

[jay_s_uk]

@peirof if your extruder mapped in M584?
e.g.

M584 X0 Y1 Z2 E3

[peirof]

@jay_s_uk

think can be this, now i am not in home.

Extruder stepper motor its connected to Shocket E0_MOTOR, this correspond to Drive 3. No?

but, now, i am not sure. Its possible that Extruder stepper its connected to Shocket E1_Motor, thar correspond to Drive 4....

Later check

[peirof]

@jay_s_uk said in I am near.... but:

M584 X0 Y1 Z2 E3
@jay_s_uk since NOW you are one of the my best friends..... solved. Now extruder appears in DWC.....

Thx to all