Duet 3 Mini 5+ blown stepper on first move
-
So, while testing my brand spanking new Duet board, it blows on the first move, got fireworks flying and all.
This was an "upgrade" from a Duet2 Wifi so cables and steppers were printing fine.
This is driver #2 connected to ZBoard: Duet 3 Mini 5+
Serial: 202101-0093Can I please get an RMA approval?
-
Ouch, what was the current set at?
When and where did you purchase your Duet?
-
@phaedrux said in Duet 3 Mini 5+ blown stepper on first move:
Ouch, what was the current set at?
1000mA
M906 X1200 Y1200 Z1000 E800 I30 ; set motor currents (mA) and motor idle factor in per cent
When and where did you purchase your Duet?
It was bought from RatRig in May 2021
-
Please send an email to warranty@duet3d.com and CC your reseller. Include a link to this forum thread and the details of your original purchase. You'll receive a reply with a form to fill out.
-
@phaedrux said in Duet 3 Mini 5+ blown stepper on first move:
Email sent, thank you for your support
-
Just to close the loop, super speedy RMA process, new board has helped chew almost an entire spool of filament
