SSD Files

Hayden1993

I'm in the process of setting up my cnc machine using the duet3, I had to format the sd card as it wouldn't read it.. Can anyone supply me with the latest files to copy over please?

Any help would be much appreciated

droftarts

@hayden1993 See https://duet3d.dozuki.com/Wiki/SD_Card#Section_Creating_the_file_structure

While the configuration tool doesn't create a CNC machine very well, just create a basic config and then edit it later. See https://duet3d.dozuki.com/Wiki/Configuring_RepRapFirmware_for_a_CNC_machine

Ian

o_lampe

@hayden1993 said in SSD Files:

I had to format the sd card as it wouldn't read it..

Did you know it needs a specific formatter tool for SD-cards? I don't know where I found mine, but it's called SD card-formatter from Tuxera

Hayden1993

@o_lampe

Thanks, I think this is where I'm going wrong as it was still showing files on it afterward.

Thank you

droftarts

@hayden1993 on the same page I linked earlier https://duet3d.dozuki.com/Wiki/SD_Card#Section_Formatting

Ian

Hayden1993

@droftarts

Thank you!

With regards to creating the new image, I haven't got a clue on the settings I need, is there a default/standard image/SSD file I can download that would have come with my version of duet3?

Hayden

droftarts

@hayden1993 use the configuration tool defaults but select your board and firmware version on the second page. It will probably force you to chose some endstops and heaters (delete the heaters as you’re configuring a CNC), then create the configuration set. You’ll get a zip file. Decompress this and copy the sys and www folders to the SD card. Follow the ‘getting connected’ guide to set up networking.

There is an SD card image, but it is big as it has the setup for Raspberry Pi on it too, and you’re going to have to go through the config stage anyway.

Ian

Hayden1993

@droftarts

Okay thank you, I'll try and get it done this afternoon and hopefully see some movement.

droftarts

@hayden1993 well, for movement, you WILL need to know some configuration values for your motors. There is a page on the configuration tool to set motor max speed, acceleration and stepper driver current. Find these out and put them in. Use conservative values to start with.

Ian

JADoglio

You should find more than you need here.

https://betrue3d.dk/rpi-and-duet-3-why-and-how/

https://github.com/Duet3D/DuetSoftwareFramework/wiki/SBC-Setup-Guide

https://duet3d.dozuki.com/Wiki/Getting_Started_With_Duet_3

Hayden1993

I didn't get chance to play around with the duet3 yesterday but I formatted the SD card using the mentioned program and get generated a new copy to transfer to my SD card (As below) does this look right? So now its a case of putting the SD card in and connecting to it?

Thanks

droftarts

@hayden1993 assuming that the contents of the folders is correct. There’s an example at the end of this section https://duet3d.dozuki.com/Wiki/SD_Card#Section_Creating_the_file_structure

Ian