Advise on smart effector mount with orbital extruder

gorf26

Here is a few pic's of a mount i just made, and would like some advice of if it looks doable, i haven't connected or used the smart effector as of yet, but came up with this mount. to use the direct drive..

I seem to have enough clearance for the rods and, the mount isn't hitting any of the solder pads..
and i think it should still have enough flex to trigger probe, but not sure..?

Any thoughts

Gary

T3P3Tony

@gorf26 there should be enough flex to trigger - and you can check by connecting up the VCC, GND and OUT lines and configuring it as a probe. then a tap should register a quick change in the z probe value reported by DWC.

gorf26

@t3p3tony
I have my config setup for the piezo would that setup work for a test of will need to modify it..

Thanks gary