Smart Effector slipping.
-
Cheers guys and girls.
I need some help with my new delta printer. I am running a smart effector and all seems fine except that the smart effector and durring the delta calibration there is on point ( close to the corner of the delta) that cannot be triggered as it is slipping .
If i change the sensitivity and put a lower number than 40 then it works but i would like to use with the default sensitivity . I know that there must be a problem on my build but i dont know what to look for, so any help would be much appreciated .
-
@gaou i'm not sure what you mean by slipping.
Can you post a video? -
@jay_s_uk said in Smart Effector slipping.:
@gaou i'm not sure what you mean by slipping.
Can you post a video?sure when i got home i ll post one ....
-
video: effector slipping.mp4
i think i ve found the problem. one of my magballs carriage was tilting a little. fix that and everything is back in order now...thanks anyway guys.
-
@gaou increase your dive hight (the H parameter on your M558 line)
-
@dougal1957 why ?
ok my mistake . my dive height is 10 at this moment .
-
@gaou
And also check the wires , just in case. Can happen that if the movement of the head modify the tension of the cables , in some area of the bed the contacts could be not perfect.
Plus, if is it possible don't calibrate with everything too hot (bed and nozzle) , can occur inconsistency trigger read .
