Toolboard 1.1 - Driver not present

[Loris]

@rjenkinsgb
Set stepper current to 100%
Set jerk, accelerations etc.

[Loris]

Tried with 3.4.0 beta 7
After M122 b121 the driver info is like that:
"Driver 0: pos 6560, 656.0 steps/mm,ok, steps req 6560 done 6560"

But the stepper is not working at all.

[rjenkinsgb]

Check the motor wiring?

The motors on my extruders have the centre two pins swapped compared to the axis motors.

[Phaedrux]

Are you trying to extrude without the temperature being above 160c?

[Loris]

@rjenkinsgb Wirings are ok, tested with 2 different steppers that are working on other boards (duet boards)

[Loris]

@phaedrux Driver not "drive" stepper. I tried with 200°c and using M302

[Loris]

This post is deleted!

[Loris]

Problem solved....
Is the driver.
I have another toolboard (never used, unboxed and installed) from the same reseller (filafarm.de).
Same wirings, same config, and works like a charm.
So the first Toolboard have a not working driver.
Can a moderator allow (give ok) reseller to replace this board?

[Phaedrux]

Please send an email to warranty@duet3d.com and CC your reseller. Include a link to this forum thread and the details of your original purchase. You'll receive a reply with a form to fill out.

[Loris]

@phaedrux said in Toolboard 1.1 - Driver not present:

Please send an email to warranty@duet3d.com and CC your reseller. Include a link to this forum thread and the details of your original purchase. You'll receive a reply with a form to fill out.

Done. Thanks