Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Duet 2 Wifi wont response in YAT

    Scheduled Pinned Locked Moved
    General Discussion
    2
    4
    117
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • Teacheundefined
      Teache
      last edited by

      Hi,

      I am a happy owner of a Duet 2 Wifi. Its my first board and I am very excited. I have been following the step-by-step guide to set up the Wifi connection. My Computer detects the Duet Board and I can write the Firmware via BOSSA. The Duet is shown as in the device-manager as Port (COM LPT) BOSSA Programm Port as it should be I guess. I can also connect the board with YAT, BUT the board does not respond to my commands. There is no reply by YAT. Is this normal?
      Could it be something with the SD-Card? There was none included and I set on of mine up with the manuel from DUET. Second thing I found, that there is no green light on my board. I was reading about some green LED wich should be lit.

      I hope that someone can give me a advise. I am lost right now.

      Best Regards

      alankilianundefined 1 Reply Last reply Reply Quote 0
      • alankilianundefined
        alankilian @Teache
        last edited by

        @teache

        HERE'S a page that shows step-by-step what to do if your Duet won't respond.

        Let us know the first thing that doesn't match the document as you go through the instructions.

        SeemeCNC Rostock Max V3 converted to V3.2 with a Duet2 Ethernet Firmware 3.2 and SE300

        1 Reply Last reply Reply Quote 0
        • Teacheundefined
          Teache
          last edited by

          Thanks for youre fast reply @alankilian ! 🙂

          Before I followed the instructions I coppied some folder structure on my SD-Card. After that the problem disappeared. Thats done! A was also able to connect it via WiFi and managed to open the DWS.

          I hope there rest will work as well.

          alankilianundefined 1 Reply Last reply Reply Quote 0
          • alankilianundefined
            alankilian @Teache
            last edited by

            @teache

            Well that's great!

            Good luck on getting back to printing.

            SeemeCNC Rostock Max V3 converted to V3.2 with a Duet2 Ethernet Firmware 3.2 and SE300

            1 Reply Last reply Reply Quote 1
            • First post
              Last post
            Unless otherwise noted, all forum content is licensed under CC-BY-SA