duet2 wifi not printing at stated speeds

[MikeE]

I've been using my duet2 wifi for almost 2 yrs now with no complaints. I noticed today when I bumped up the speed from 60mm/sec to 100mm/sec it had problems printing at those speeds. so to be more specific, i have my support printing at 150mm/sec and it seems just fine doing that. but when it prints both inner and outer walls on a cylinder, it slows down to 30mm/s, even though withing cura, i have it set at 100mm/s on both. im just printing pla and on a railcore 2zlt printer that i built.

i'm kinda lost here. i dont know why its slowing down. any help would be greatly appreciated.

[MikeE]

nevermind. it was a cura issue, well, my issue.

[alankilian]

@mikee

What was the setting in Cura?

It'll help the next person who runs into this issue.

[MikeE]

a guy from a facebook group told me where to look. it wasnt me. it was the min. layer time within cura. it defaulted to 12 seconds and i was trying to print a layer in under 1 second. i lowered it down to .5 second and the issue went away. the printer is spewing out plastic very fast now. ...even at 150mm/sec.