Dead Duet2?
-
It sounds like it's just missing firmware. Go through the erase and flash procedure with Bossa and see if it comes to life.
-
About to try that now, but just before i do that. Is 4,38V good enough? This is measured on the GND and 5V connector for the PanelDue (with the PD disconnected).
-
@exerqtor said in Dead Duet2?:
Is 4,38V good enough?
I'm not sure. The PD screen lights up though, right?
-
Yup it does, i've disconnected it now when i'm trying to resurrect the card though.
Can't seem to get the card to show up in device manager ( one device without correct driver shows up / dissapears when i connect/disconnect the usb though). Running windows update on the laptop now to see if that helps, or else it looks like I will have a new table coaster.
-
-
Nah that driver didn't work, allready tried that =/
-
My guess is that something got shorted out when doing your initial checks. Do you see any scorch marks on the board?
-
@phaedrux
yeah i'm leaning towards that too, I've only done a quick look for shit stains and couldn't see any. Haven't dissasembled the board and checked the backside etc. yet though. Gonna fully update the old beater laptop first before i pull out the board and give it a closer look.Anywhere specific i should be looking given the symptoms it's displaying?
-
It sounds like the CPU took a hit. You may see a spot on the chip, maybe not.
-
@phaedrux
Well in that case i will have some spares sans a CPU
