Printer stops mid print
-
@jay_s_uk Ok i will give it a try.
-
@jay_s_uk So i tried with 3.4 and it stopped again.
Here is the log file:
Syslog2.txt -
@woheho looks like you lost connection between the SBC and the duet.
Can you post a photo of the wiring between the two?
I would also suggest trying to reseat the cableOwns various duet boards and is the main wiki maintainer for the Teamgloomy LPC/STM32 port of RRF. Assume I'm running whatever the latest beta/stable build is
-
@woheho Please flash your SBC's microSD card again with our latest DuetPi/DuetPi lite image. We've had a report that the Bullseye-based DuetPi image could cause unexpected lags/disconnects and that image was the default for a few days before we replaced it again with the previous image. The older Buster-based image is not affected by the mentioned bug. We're still investigating why it occurs (perhaps a Linux kernel issue) but I have not yet figured out why it occurs on the newer image.
-
@chrishamm I am a little bit confused about the versions. When i was at 3.3 i had the 5.10.17-v7l+ kernel with buster 10. Then i updated via sudo apt-get upgrade and i am now on 5.10.103-v7l+, which is also Debian 10 (buster). So i never had the bullseye-based image on my pi right ?
-
@jay_s_uk I skrewed everything down in the beginning of my built and never touched it again. So i dont think that the cable is sitting loose or something. Could i shield the cable with tin foil or something ?
-
@woheho no issues I can see there that I can comment on
-
This post is deleted! -
-
@tidofelder Yeah, should not be an issue. This line is not used any more.
-
What kind of SD card is in use in the Pi?
-
@phaedrux Its a Sandisk Ultra 64GB Class 10 (1) Red-Grey.
-
Please send an email to warranty@duet3d.com and CC your reseller. Include a link to this forum thread and the details of your original purchase. You'll receive a reply with a form to fill out.
