6HC PanelDue Ribbon-cable

[lbtqsb]

Hi,
I am currently trying to follow the guide for using the sd-card on the PanelDue with 6HC
https://docs.duet3d.com/User_manual/Connecting_hardware/Display_PanelDue

Is the Orientation
A)

or
B)

(Do not worry - board of course is not powered…)

Thanks in advance! Cheers!

[Phaedrux]

You'd need to compare this table

https://docs.duet3d.com/en/User_manual/Connecting_hardware/Display_PanelDue#duet-3-mb6hc-using-ribbon-cable

With the pinout from the wiring diagram for the 6HC

https://docs.duet3d.com/duet_boards/duet_3_mb6hc/duet_3_mb6hc_wiring_diagram_v1.0_v1.01.png

[dc42]

@lbtqsb it's B, with the red stripe on the end near the CAN connector.

[lbtqsb]

@phaedrux
Thanks so much! (Sorry for my lazyness…)

Is this correct then:

Wondering why only (beside the RED being 10 (?)) only the most outer 2 and not 4 are cut away then?

Or is my interpretation the wrong way round?

@dc42
Thanks for the fast reply!
Did I get it right or wrong with the little paper-schematic?

Thanks! Cheers!

[lbtqsb]

This post is deleted!

[dc42]

@lbtqsb the red stripe should be the Pin 1 conductor, not pin 10.

[lbtqsb]

@dc42

Thanks PanelDue now works! (Ups, so I got the theory upside down, looking on the paneldue-pcb with the pins pointing not towards you but out backwards, I think I got it all wrong from then on, anyway, as long as it works in reality…)