How do I wire 5Vext on a 6xd?

[markz]

@rushmere3d not soldering in pins is a serious feature since I was planning to jumper the middle one cuz I read the doc wrong.

[jay_s_uk]

@markz the VFD output can be used for one as that's 5v. Are you just using them for ON/OFF or PWM control?

[markz]

@jay_s_uk Just on/off.

I've already ordered 2 24V relays but still would rather not swap them in if there's another 5V output I could use. Thank you.

[jay_s_uk]

@markz you may be able to use an IO out. Otherwise take 5v from elsewhere on the board and use that with a fan output

[markz]

@jay_s_uk If I read the schematic right the output is just a mosfet load/ground so it looks like I could use 2 pins of (+5V_int , fan-io output) to drive the relay?

[jay_s_uk]

@markz yes, it just switches on ground. So 5v from somewhere to the switch output on the fan

[markz]

@jay_s_uk Thanks a bunch.

[markz]

@jay_s_uk This sounds strange but looking at the circuit can't I just run 5V to the V_OUT_LC_2 post and not use a jumper to either usual voltage? As far as I can tell it's a small self-contained run to out6,7,8 which works for me.

[jay_s_uk]

@markz that should also work

[dc42]

@markz said in How do I wire 5Vext on a 6xd?:

@jay_s_uk This sounds strange but looking at the circuit can't I just run 5V to the V_OUT_LC_2 post and not use a jumper to either usual voltage? As far as I can tell it's a small self-contained run to out6,7,8 which works for me.

Yes it's designed to allow you to supply a different voltage to the centre post of the 3-pin voltage selector block.

[markz]

@dc42 @jay_s_uk Thank you both for the info.

ps: I just tried this and it worked like a champ.