Euclid facility

[A Former User]

@phaedrux
I deleted my deploy and retract and I didn't save

[Phaedrux]

@sgk said in Euclid facility:

retractprobe.g homez.g homeall.g deployprobe.g config.g bed.g

want the files in raw or it goes in ZIP

Good thing you uploaded them here.

[A Former User]

@phaedrux yes nice

[A Former User]

it works but not very well every time the probe feels it comes home

[A Former User]

I will make a video

[A Former User]

and above all it does not balance the left and right bed

[A Former User]

https://youtu.be/Iv2z8CIwCVc

[A Former User]

[jumpedwithbothfeet]

@sgk Have you changed bed.g to what @Phaedrux suggested? it should now look like this -

; bed.g
; called to perform automatic bed compensation via G32
;
; generated by Ben Levi - BLV developer as a basic version
 
M561 												; clear any bed transform
G91               									; relative positioning
G1 H2 Z5 F6000   									; lift Z relative to current position
G90              									; absolute positioning
G28 												; home all
 
M401 ; deploy Z probe (omit if using bltouch)
G30 P0 X10 Y175 Z-99999 							; probe near a leadscrew, half way along Y axis
G30 P1 X330 Y175 Z-99999 S2 						; probe near a leadscrew and calibrate 2 motors
M402 ; retract probe (omit if using bltouch)                  
 
M291 P"Leveling finished !" R"Probing.." S1 T2
 

once you have done that go into your deployprobe.g find the line that says -

G0 X170 Y170 G3000 ; move to the center of the bed

and change it to read to read, to correct the warning -

G0 X170 Y170 F3000 ; move to the center of the bed

[A Former User]

hello to all of you it's finally starting to work thank you to all of you. I have to settle because the probe often comes home before doing g32 or g29. but it works it works thank you thank you thank you you're really king

[A Former User]

thank you to all and to the group