2 heater on Duet 1LC- Wiring. Series or parallel?

IndeX4D

hey lovely community,
I bought a bondtech lgx with the magnum plus which has two options for heater and thermistors. Of course, I want to use them.
Is there a describtion about how to wire both heater onto the Duet Toolboard and how to do it with two thermistor. Like one is just for safety?

Would be lovely to get a link or a little help.
Heater: heatlink bondtech 50w 24v
Duet 3

Thanks a lot!

IndeX4D

@index4d

https://support.sliceengineering.com/portal/en/kb/articles/mosquito-magnum-dual-heater-configuration-for-reprapfirmware

IndeX4D

@index4d

Thanks a lot

dc42

@index4d in RRF 3.4 and later there is a third option:

Single logical heater using two outputs. Example:

M950 H1 C"out1+out2" T1 ;2 Heaters wired to separate outputs but treated as a single heater