How do I use the BL-Touch When homing Z-axis

TomasL

@jay_s_uk
Well, that whas what RRF put in the config.g
So, How do I use the G30 code?

jay_s_uk

G1 X100 Y100
G30

obviously changing the move location to the centre of the bed, taking into account to offset of the probe as the firmware won't

TomasL

@jay_s_uk
Ok, so I,ll put this in the config.g, presumably at the end.
So it would read

G1 X33,5 Y82,5 Z5
G30

If I do this via the console, Z stops att 2,43 (+5mm) I do assume that the X-axis is lifted 5 mm after the g30 command.

jay_s_uk

@tomasl not in config, in your homing files

jay_s_uk

@tomasl and if you want any further movements after the probe then you'll need to add those in

TomasL

@jay_s_uk
Ok, I have put in homeall.g and homez.g

G1 X33,5 Y82,5 F6000
G30

However Z-level is the same as the trigger height, is that correct?

jay_s_uk

@tomasl the height it'll set is the z offset that you've set in G31 in your config

TomasL

Phaedrux

For the record

TomasL

@phaedrux Yes, I know all that, however my question was not answer in those documents.

droftarts

Ian