HELP! Duet 2 WiFi Configuration and DWC Upload???

[Phaedrux]

Well if the IP address is DHCP from the router there is a chance it could change occasionally. The best thing to do would be to set up a IP reservation in the router config so that it doesn't change.

[PCNoobNeedsMajorHelp]

@phaedrux

How do I do that?

[Phaedrux]

That will depend entirely on your router.

[PCNoobNeedsMajorHelp]

@phaedrux

ok I'll look into it

[PCNoobNeedsMajorHelp]

@phaedrux

Thanks

[Phaedrux]

If you can find a manual it would probably be found under "DHCP reservation".

[PCNoobNeedsMajorHelp]

@phaedrux

So I'm testing some new filaments, and on the technical data sheet it says for the print bed to be at 140°c. I'm almost positive mine maxes out at 110, which means i need to upgrade. Do you have any suggestions.

I was thinking these (one generic, one brand)

https://www.amazon.com/gp/product/B07GJGCBNP/ref=ox_sc_act_title_1?smid=AJUKUXZVPYM6H&psc=1

https://keenovo.store/products/keenovo-silicone-heater-235mm-x-235mm-for-ender-3-3d-printer-build-plate-heatbed-heating-upgrade

What's your take on it?

Thanks,

-Carson

[Phaedrux]

Keenovo has a good reputation and I wouldn't bother with anything else.

There are lots of places to be cheap, but power supplies and heaters aren't one of them.

[PCNoobNeedsMajorHelp]

@Phaedrux
(I decided to reply to this thread so you'd remember me)

Hey...It's been a while. After a very busy year I'm finally ready to install my Keenovo Heated bed upgrade. I think I got the wrong heated bed though. I have a 24v 350w Keenovo, and I have a 24v 350w power supply as well as an SSR. I was reading up on the stock heated bed for the Ender 5 and it's a 24v 350w bed as well (facepalm). I'm realizing now that I should have gotten a 110v 500w heated pad for higher temperatures for my bed plate where I would be pulling power from the Mains on my PSU rather than the 24 volts it supplies to the rest of the Duet. Am I correct in my thinking?

Thanks in advance for any guidance

[droftarts]

@PCNoobNeedsMajorHelp Please start a new thread for a new subject; this thread is already 200 posts long! You can always reference this original thread from the new one.

Ian

[PCNoobNeedsMajorHelp]

@droftarts

Do you want me to post another one for this question or just for next time?

[droftarts]

@PCNoobNeedsMajorHelp Make a new thread for this question. Make the title specific for greater visibility and more useful responses.

Ian