I'm hoping a backup config saved my life ?
-
Not run my BLV cube ( mini v3 x 5 )for a while because I broke a part holding the cables, So today was print that part and get it back on the road again .
Fixed the printer easy, but the Z-offset was off , so it was do a height map and see what's up .
Booted and got a you are missing the config.g and config.bak , so doing a run mash calibration just deleted my config.g file , not happy , BUT LUCKY ME a made a old copy of the config.g .
Back to working , but this should not really happen ?. -
What firmware version are you using? Which board?
-
@Phaedrux
M122
=== Diagnostics ===
RepRapFirmware for Duet 3 Mini 5+ version 3.3 (2021-06-15 21:46:11) running on Duet 3 Mini5plus WiFi (standalone mode)
Board ID: MZSV6-S096U-D65J0-40KMD-3413Z-R7859 -
Please update your firmware to 3.4.5
There were certain edge cases where the config.g file could get lost on older firmware. This may have been the case here.
Upload this zip file to the system tab in DWC.
https://github.com/Duet3D/RepRapFirmware/releases/download/3.4.5/Duet2and3Firmware-3.4.5.zip