PID Dont stop forever..
-
Ji i just did pid to the bad and the its just going up and down for 30 minuts now and still...
whats the problem ? -
@Melacko3004 Its just right now stoped...
and its says :Warning: heater behaviour was not consistent during tuning
Auto tuning heater 0 completed after 4 idle and 25 tuning cycles in 2407 seconds. This heater needs the following M307 command:
M307 H0 R0.486 K0.846:0.000 D3.51 E1.35 S1.00 B0
Send M500 to save this command in config-override.g?????
-
@Melacko3004 just save it and carry on. it "should" be ok
-
@Melacko3004 said in PID Dont stop forever..:
?????
Duet is well documented. "Making new heater parameters persistent" describes two options how to store the tuning results.
-
What size is the bed? How powerful is the heater? Where is the thermistor placed?
-
OK Thank you
