E3D Rapidcahange Revo jam

[Pertti]

Hi! Sorry to say, but I found it hard to pull out this nozzle of the heatblock. By warming it up by torch it was possible to remove it. Usually You can pull it out with no effort but now I discovered some dark material (propably filament) around the neck of the nozzle. Propably it acts as an insulation, because printing was impossible due blockage.
Perhaps the nozzle leaked from the joint. Left in the picture is a not used nozzle.

[droftarts]

@Pertti Maybe contact E3D on their forums? https://forum.e3d-online.com/

Ian

[Pertti]

@droftarts Done!

[elmoret]

@Pertti E3D really doesn’t use their forums much, best to contact them at support@e3d-online.com.

[Pertti]

@elmoret Done.
Meanwhile I made a quick repair by recycling used heatblock and thermistor. I also sealed the tube parts with silver soldier