Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    TOOL BOARD V1.3 --> DUET3 6HC

    Scheduled Pinned Locked Moved
    Duet Hardware and wiring
    2
    3
    106
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • nico.rastundefined
      nico.rast
      last edited by

      Hi guys!
      I have just purchased a toolboard v1.3. Following the wiring diagram, I noticed that it is indicated to wire CAN 1, which is the one installed with the RJ11 connector. Observing the duet 3 6hc, I noticed that it has another CAN connector, CAN0. Can I use that one? I don't have an RJ11 connector on hand 🙂

      Thanks!

      gloomyandyundefined 1 Reply Last reply Reply Quote 0
      • gloomyandyundefined
        gloomyandy @nico.rast
        last edited by

        @nico-rast I'm afraid not. See: https://forum.duet3d.com/topic/32916/6hc-can-0-connector?_=1710591789062

        nico.rastundefined 1 Reply Last reply Reply Quote 0
        • nico.rastundefined
          nico.rast @gloomyandy
          last edited by

          @gloomyandy didn't see 😞
          I m going to order a couple of RJ11.

          Thanks

          1 Reply Last reply Reply Quote 0
          • First post
            Last post
          Unless otherwise noted, all forum content is licensed under CC-BY-SA