Unresponsive duet 3 6HC board
-
@gsch1803 here are a few things to try:
- Send M552 from Yat and see what the response is
- Send M122 from Yat. See what it reports for Interface state in the Ethernet section near the end.
- Run ping 192.168.2.1 on the PC.
-
@gsch1803 are you setting a static IP address with M552? Have you tried a different Ethernet cable to the Duet, or checked the one you’re using with another device?
Ian
-
@dc42 Thank you for the response, when I send M552 I get:
M552
Ethernet is enabled, configured IP address: 192.168.2.1, actual IP address: 192.168.2.1
ok
I will try sending M122 when I get a chance to work with the board again. When I would attempt pinging the board I wouldn't get any response.It seems that there is no communication going through the cable whatsoever. I have tried using the cable else where and confirmed that it does function though.
-
@droftarts Thank you for getting back to me. The static IP is set in the config file and verified via the M552 command. I have tried a couple ethernet cables with no luck and confirmed they work with other devices.
-
Have you followed this when trying to do a direct Duet to PC connection?
https://docs.duet3d.com/en/User_manual/Machine_configuration/Networking#wired-direct-connection
-
@Phaedrux Hi, thanks for the reply. Yes I followed that guide to get the board setup initially but since these connection issues have started this sort of approach no longer works. Computers won't even recognize a device has been connected when the duet ethernet is plugged in.
-
When and where did you purchase the Duet?
-
@Phaedrux I believe it was purchased from Amazon in October
-
@gsch1803 what colour is the PCB?
-
@jay_s_uk Dark blue
-
@gsch1803 said in Unresponsive duet 3 6HC board:
@Phaedrux I believe it was purchased from Amazon in October
Who is the amazon seller?