Duet3D Logo Duet3D
    • Tags
    • Documentation
    • Order
    • Register
    • Login

    Duet custom board on Fusion3 F410

    Scheduled Pinned Locked Moved
    Duet Hardware and wiring
    3
    5
    125
    Loading More Posts
    • Oldest to Newest
    • Newest to Oldest
    • Most Votes
    Reply
    • Reply as topic
    Log in to reply
    This topic has been deleted. Only users with topic management privileges can see it.
    • jfhuntundefined
      jfhunt
      last edited by

      Does anyone know if the custom board that was built for the Fusion3 F410 has any extra control pins that might be able to control a 12v or 24v switch or relay activated by gcode? It would be similar to what is used in many smaller tabletop laser or cnc's where a solenoid is opened to start air flow for the laser or other device.

      Any thoughts?

      dc42undefined elmoretundefined 2 Replies Last reply Reply Quote 0
      • dc42undefined
        dc42 administrators @jfhunt
        last edited by

        @jfhunt the only controllable outputs on that board are the four OUT ports.

        Duet WiFi hardware designer and firmware engineer
        Please do not ask me for Duet support via PM or email, use the forum
        http://www.escher3d.com, https://miscsolutions.wordpress.com

        jfhuntundefined 1 Reply Last reply Reply Quote 0
        • jfhuntundefined
          jfhunt @dc42
          last edited by

          @dc42 , I've not opened up the side panel yet to look. What are the four out ports for? There are two x-y steppers, one hot-end extruder, there are then two fans, one exhaust the other is the hot end cooling fan. That's 5. I'm new at this.

          dc42undefined 1 Reply Last reply Reply Quote 0
          • dc42undefined
            dc42 administrators @jfhunt
            last edited by dc42

            @jfhunt I wasn't counting the stepper motor output.

            OUT0 is a high current output suitable for a hot end heater.

            OUT2 is a lower current output with VIN on the positive pin, suitable for a fan that takes VIN voltage. It includes a flyback protection diode.

            OUT1 and OUT3 are supplied with 5V on the positive pin, intended I think for 5V fans. However the mosfets switching them are rated much higher, so OUT1_NEG and OUT3_NEG could be used to switch higher voltage loads. There are no flyback protection diodes on these outputs.

            Duet WiFi hardware designer and firmware engineer
            Please do not ask me for Duet support via PM or email, use the forum
            http://www.escher3d.com, https://miscsolutions.wordpress.com

            1 Reply Last reply Reply Quote 0
            • elmoretundefined
              elmoret @jfhunt
              last edited by

              @jfhunt said in Duet custom board on Fusion3 F410:

              Does anyone know if the custom board that was built for the Fusion3 F410 has any extra control pins that might be able to control a 12v or 24v switch or relay activated by gcode? It would be similar to what is used in many smaller tabletop laser or cnc's where a solenoid is opened to start air flow for the laser or other device.

              Any thoughts?

              You might want to post a photo or two of the board you're talking about, if its one I'm thinking of its not made by Duet so no one here is going to know what you're asking about.

              1 Reply Last reply Reply Quote 0
              • First post
                Last post
              Unless otherwise noted, all forum content is licensed under CC-BY-SA