Inquiry About Using SZP for Bed Auto-Levelling

[R006]

Hey,

I would like to inquire about using the SZP sensor for bed auto-levelling, similar to how the BL-Touch operates.
Is it possible to use only the SZP sensor for both bed auto-levelling and mesh bed levelling?

I would appreciate any suggestions or guidance you could provide on this.

@dc42 @Phaedrux @fcwilt @gloomyandy @oliof

[dc42]

@R006 that's supported experimentally. See https://docs.duet3d.com/en/User_manual/Tuning/scanning_z_probe_calibration#using-the-szp-in-touch-mode-to-set-z-height.