smart effector not working

Monster Delta

@dc42 tapping it sometimes does leaving it for a few hours will sometimes get it to respond but soon reverts to either not working at all or the 2 flashes but it really seems random i even soldered the crimps onto the wires but i cant seem to find one particular thing that provokes a response

dc42

@monster-delta said in smart effector not working:

@dc42 tapping it sometimes does leaving it for a few hours will sometimes get it to respond but soon reverts to either not working at all or the 2 flashes but it really seems random i even soldered the crimps onto the wires but i cant seem to find one particular thing that provokes a response

OK, if you think the effector is faulty, please ask your supplier to replace it. See https://www.duet3d.com/warranty.

Monster Delta

@dc42 ok will do thanks for your time

Monster Delta

I filled out the warranty form on monday morning but i havn't received a response yet

T3P3Tony

@monster-delta I have highlighted this

Monster Delta

@t3p3tony thankyou

Monster Delta

Replacement received promply and now this one is doing weird things. I went to run calibration this morning and at first it wouldn't do much and after a few reboots it sprung into life but now it constantly triggers erratically and the values bounce around from 0 to 1000 and various values in between i checked the voltage and it is is 3.3v un plugged the fan and the hotend and removed the arms but it makes no difference

dc42

If the reading bounces around without the green LED flashing or flickering in sympathy, that suggests a bad crimp connection in the output wire from the effector to the Duet Z probe input.

Monster Delta

The green light does flash randomly without any kind of pattern to it

adavidm

Out of interest, have you ever had a probe working on your Duet, and which revision of the Duet do you have? I got caught out by the fact that there are differences in the pinout on the Duet's probe connector depending on the revision. My (white) prototype board has the opposite pinout to the (blue) production board.

Diagrams showing both are available here:

https://duet3d.dozuki.com/Wiki/Duet_Wiring_Diagrams

adavidm

dc42

@monster-delta said in smart effector not working:

The green light does flash randomly without any kind of pattern to it

If it flashes randomly with no heaters or fans turned on, and you haven't increased the sensitivity, that suggests a hardware fault - possibly in the effector, but more likely a bad crimp connection in the +3.3V or ground wire between the 8-pin connector and the Duet.