Printing problems
-
Hi there! i,m working on my custom delta printer, everything works fine so far, i can move the axis well, the heating control works fine, the bed compensation works well....but when i try to print something, it starts heating up, then it makes the bed levelling and after that it stops and in the screen you can see the printing process bar being completed like in 20 seconds until reaches 100% and it goes back home. there is no error message in the console, just says it has been printed already but it does nothing. what can i check? i´m currently using simplify 3d but i also tryed cura, with same results
-
Please make available to us one of the GCode files you are trying to print.
-
-
hi there! i just wanted to say that i found the solution, the problem was on the simplify configuration, thanks
-
@ander can you share what it was to help people who have the same issue
