Paneldue 7i not connecting to Duet 2 wifi

Excelon

After setting up the Duet 2 Wifi and getting the printer functioning (not printing but all axis working) I connected the Paneldue 7" but in the top right hand corner it displays "CONNECTING".

Duet 2 wifi is running 2.02RC5
Paneldue is V2 running 1.21.2

I am a total noob so please excuse if I am missing the obvious but I am switching over 2 machines to Duet 2 wifi boards.

dc42

On the Settings page of PanelDue, check that the baud rate is set to 57600.
If you have a M575 P1 command in your config.g file on the Duet, check that the B parameter in it is also 57600.
Are you using the ribbon cable or the 4-way cable? If it's the 4-way cable, check that the Transmit and receive data pins are properly connected.

Excelon

@dc42 FIXED!!! Thank you. More questions to come...

Excelon

@dc42 Question.... Should I be able to see the contents of the SD card in the Duet board from the Paneldue?

dc42

@excelon said in Paneldue 7i not connecting to Duet 2 wifi:

@dc42 Question.... Should I be able to see the contents of the SD card in the Duet board from the Paneldue?

Yes, press the SD card icon on the Control page and you should see the GCodes file list.

Excelon

@dc42 When I do it says "Files on card 0"

dc42

Do you have any files in the /gcodes folder of that SD card?

Excelon

@dc42 At the time, no. I transferred a file over to the /gcode folder and was able to see it on the Panledue. It's my understanding that you are only able to see files in the /gcode folder to select for printing?

dc42

@excelon said in Paneldue 7i not connecting to Duet 2 wifi:

@dc42 At the time, no. I transferred a file over to the /gcode folder and was able to see it on the Panledue. It's my understanding that you are only able to see files in the /gcode folder to select for printing?

Yes, you can see files in /gcodes and its subfolders. If you press the Macros button, you can see files in /macros and its subfolders.