Turn off Z-probe when printing?
-
My zprobe will go nuts (clicking) when printing sometimes. Specially when going over a printed area. Is there a command to turn off and on the zprobe. Could put at end of start code and end end code to turn back on.
-
What kind of z probe is it?
-
*taking crystal ball *
since it clicks I would assume a BLTouch (or clone) but who knows?
-
Its a capacitive sensor probe. Sorry, the clicking is the relay.
-
@twistedfab13 said in Turn off Z-probe when printing?:
Its a capacitive sensor probe. Sorry, the clicking is the relay.
No need to use a relay, see https://duet3d.dozuki.com/Wiki/Connecting_a_Z_probe#Section_NPN_output_normally_open_inductive_or_capacitive_sensor or https://duet3d.dozuki.com/Wiki/Connecting_a_Z_probe#Section_PNP_output_normally_open_inductive_or_capacitive_sensor depending on which type you have.
