Its a capacitive sensor probe. Sorry, the clicking is the relay.
Latest posts made by twistedfab13
RE: First Print (Cube) - Let just say it ugly
I did the extruder calibration and once calibrated it seemed to be dead on.
Hatchbox 1.75 PLA
Printing Temperature 200
Printing Temperature Initial Layer 200
Initial Printing Temperature 190
Final Printing Temperature 185
Printing a temperature tower to check the temps for this new roll of PLA.
First Print (Cube) - Let just say it ugly
So I went to the my first print and I chose the Cube.
I am using Cura 3.5.0 for the slicer. It seemed to start out great but then thing went horribly wrong.
The first few layers look correct then it just started shifting. Then is just decided to move to a different location and print.
Here are my Cura settings for the printer that I added:
I am so close I can taste it. Any idea what I am doing wrong.
RE: Hot end auto-tuning keeps failing
Yah figured it out. Was doing the mesh compensation. When I looked at the mesh it was really bad and all over the place. Long story short the fan cable was too close to the probe and it was registering all the time. LOL. Quick fix and now the test print it laying down correctly.
Thanks for the help!!