Extruder 0 reports too little movement

[unstableTable]

New install on Ender 3, obvious under extrusion on the bed. Tried keeping extrusion clip very loose on the extruder thinking it was a failure to feed filament.

If it's a firmware tuning issue then I'm not sure where to start?

[Phaedrux]

https://forum.duet3d.com/topic/5909/guide-for-posting-requests-for-help

[dc42]

You are evidently using a filament monitor. What type of filament monitor is it? How have you configured it in config.g? Have you calibrated it?

[unstableTable]

@dc42 I am not using a filament monitor of any kind. But I suspect that I have improperly wired the board.

I can get all 3 axes to home properly.
Nozzle and bed get to proper temp.

Any print stops within 2 min and "Extruder 0 reports too little movement"

[AndreS]

Check for any M591 commands in your config.g
Post your config.g
After the print aborted type M591 D0 in the console and show the report.