@TNO_Marc also why do you want to reset E1 and E2? Are you using these values outside of reprap firmware? They are predominantly there dort the firmware to keep track of extrusion.

@botanic2000 said in G92 not working for E axis:

Has run into same issue with E-axis today. Was trying to set up print resuming after power loss and found out that RRF is ignoring G92 command in the "resurrect.g" file.
Basically, what happens is when I resume printing after power down the print head goes over the print and then it starts extruding all the way from 0 to the value that has been stored in "resurrect.g".

What am I doing wrong here?

Firmware Version: 2.01(RTOS) (2018-07-26b2)

1_1537273182573_resurrect-prologue.g 0_1537273182573_resurrect.g

Please post the ResTest.gcode file too, or put it on a file sharing site so that I can download it.