DWC2: Slicer estimation starts counting down during warmup phase
-
Hi, in RRF 2.03, it looks like the print estimation by the slicer starts counting down during the warmup phase. This is just a couple minutes difference, but I am pretty sure slicers know nothing about time to temp. IMHO the slicer estimate should only start counting down after warmup has completed.
-
@oliof Where are you seeing the print estimation generated by the slicer?
If it's the web interface, then those estimations are not generated by the slicer but by the web interface itself. And the warm up time start from when you select a file to print and stops when the first print move happens.
-
@deckingman in DWC2, the slicer estimate is shown in addition to the layer, file, and filament estimates. Those start after warm-up.
-
@oliof said in Slicer estimation starts counting down during warmup phase:
@deckingman in DWC2, the slicer estimate is shown in addition to the layer, file, and filament estimates. Those start after warm-up.
Ahh, sorry. I'm still on DWC1.22 so it's a DWC2 problem then. Maybe you ought to amend the title to bring it to the attention of @chrishamm
