Firmware Quad Colors

[bandulaadrian]

Thanks for the reply but I have already tried this page and a few more.

[dc42]

@bandulaadrian said in Firmware Quad Colors:

but it does not work

You will have to be more specific than that.

[bandulaadrian]

Hello,
Here's what I last used:link text

Thanks

[bandulaadrian]

Hello

I have a question,why does this temperature show me?
It may be because they are not connected the extruder and bed. .

Thanks

[dc42]

Yes, it probably means that the temperature sensors are not connected.

[bandulaadrian]

Thanks

It was really because I didn't connect the extruder and bed.I'm trying to do some tests now.

Thanks again

[bandulaadrian]

Hello

How can I change motor direction for home .

Thanks

[dc42]

Are the motors moving the wrong way when you jog them (you can enable jogging before homing by sending M564 H0); or are they moving in the correct directions but trying to home at max instead of min (or vice versa)?

[bandulaadrian]

Hello

They were even heading in the wrong direction,I checked the connectors, I reversed them and now its OK.

Thank you very much

[dc42]

The other way to change motor directions is to change S0 to S1 or vice versa in the M569 commands in config.g.

[bandulaadrian]

Hello,

When I connect the printer gives me this answer:
I do not understand why, because it is the fourth time I want to use it.
Thank you for any help