Thank you for your help guys it really works now.
I'm at the beginning with this electronic board.Thanks again and see you soon.

Hello,

When I connect the printer gives me this answer:
I do not understand why, because it is the fourth time I want to use it.
Thank you for any help

Hello

They were even heading in the wrong direction,I checked the connectors, I reversed them and now its OK.

Thank you very much

Hello

How can I change motor direction for home .

Thanks

Thanks

It was really because I didn't connect the extruder and bed.I'm trying to do some tests now.

Thanks again

Hello

I have a question,why does this temperature show me?
It may be because they are not connected the extruder and bed. .

Thanks

Hello

Thanks for your help I was able to make the connection T3P3Tony.
I'll try the change firmware now.

Thank you again

Thank you guys for the answer ,I tried the variants but nothing.I took pictures again.I do not understand why.
If you can tell me why?

Thanks

Thank you for the answer but
I tried both addresses but it doesn't work.I don't understand why he showed me two different addresses.

Thank you

Hello
Tanks for the answer I tried to connect the board but nothing.You have here the image. . If you can give me a suggestion.
Thank you for help

Hello

I have a problem with finding the IP address.I sent M552 S1 but no address returned,I waited more than a minute but nothing.I have a picture here. .

Thank you for your help