Z probe already triggered at start of probing move
-
I just installed a Titan Aero on my Ender 3 and I am doing a bit of testing. Everything seems to be working fine other than I get a "Z probe already triggered at start of probing move". I unplugged the cable from the BLTouch when I installed it on the new mount and it is seated about as firmly as it can be. I never unplugged any of the BLT cables from the Duet 2 wifi. X and Y homes great.
As always, I very much appreciate the help!
Pat
retractprobe.g
homez.g
homey.g
homex.g
homeall.g
deployprobe.g
config.g -
@BearcatTD said in Z probe already triggered at start of probing move:
"Z probe already triggered at start of probing move"
this indicates faulty wiring. even with the pin up this should not happen on a bltouch.
check each wire for their correct placement, -
Right. Currently, the pins are connected based on the guide:
https://duet3d.dozuki.com/Wiki/Connecting_a_Z_probe
I think I might just put on new connectors just for kicks to see what happens
Thanks!
-
White wire needed repair! Thanks.
Follow up question inbound!
