Control of Keenovo heat bed.

[dc42]

Yes, it's been implemented for a long time.

[Garfield]

No worries - needs updating in the documentation.

[dc42]

@droftarts, please fix this, also check whether the RRF3 wiki page has the same error. I'm on a smartphone, otherwise I'd do it myself.

[Garfield]

It's OK on reprap.org

On this page it says not yet implemented

https://duet3d.dozuki.com/Wiki/Gcode#Section_M950_Create_heater_fan_or_GPIO_servo_pin

[droftarts]

@dc42 Updated Gcode page, removed "not yet implemented". https://duet3d.dozuki.com/Wiki/Gcode?revisionid=HEAD#Section_M950_Create_heater_fan_or_GPIO_servo_pin
RRF3 wiki page was correct already. https://duet3d.dozuki.com/Wiki/RepRapFirmware_3_overview#Section_M950_Create_heater_fan_or_GPIO_servo_port

Ian