CR10v2 - Duet 3 Connections
-
@BearcatTD see edit
-
Thanks! Yes, I used the config utility online to get the above config.g file. I'll edit the file with your suggestions and give it a go!!
-
@BearcatTD said in CR10v2 - Duet 3 Connections:
Yes, I used the config utility online to get the above config.g file
could you upload the config.json file it procuced? I would think devs would want to look at that if thats the output you got.
-
Will do!
-
that is very strange, only issue I could see is the bltouch was split betwwen io4 and io7 , endstops should have come out as io1 and io2, smells like a bug.
-
I'm glad to help...LOL!
-
haha, you can laugh but if it saves someone else from banging their head against the wall its well worth it!
-
Amen to that. Usually I'm the one doing the head banging. And not in an awesome 80' Rock way.
-
@bearer said in CR10v2 - Duet 3 Connections:
https://duet3d.dozuki.com/Wiki/Connecting_a_Z_probe#Section_Duet_Num_3
So here is the BLTouch Duet 3 hookup
I get the impression that the ground pin will have two wires?
I get the impression that the ground pin will have two wires?
-
Dealers choice. They're connected internally in the BLTouch and won't carry much current, so 1 or 2 will be fine when all connectors go to the same header imo. (but i suspect there are two grounds to insure signal integretry for RAMPS boards where the signal and pwm are split to different headers)
But yeah, I'd join them, its tidyer and you don't have one lead flapping about.
