Need help with initial setup.

[rsbkh]

So I finally have everything wired up and it powers up nicely. No sparks. Lights are all on that should be on. Can't get anything to move. I'm getting some error message that all axes aren't homed. Not sure where to go from here.
Sorry, It's a Corexy setup with duet 2 wifi controller.

[A Former User]

@rsbkh said in Need help with initial setup.:

I'm getting some error message that all axes aren't homed.

thats normal; set up your endstops and homing fixes it.

to override the safeguards see M564 H0

https://duet3d.dozuki.com/Wiki/Gcode#Section_M564_Limit_axes

[Chriss]

@rsbkh

You can start here:
https://duet3d.dozuki.com/Wiki/ConfiguringRepRapFirmwareCoreXYPrinter

The axes can be homes by pressing one of the orange the buttons. ("HOME X" ...)

[rsbkh]

@Chriss No, they don't work. Tried that and nothing happens.

[A Former User]

@rsbkh said in Need help with initial setup.:

Tried that and nothing happens.

then your endstops are likely not set up right. post your config and homeall files?