printing time and data.
Recently I start a print and my slicer told me arround 21Hrs, I know that is not the right time, it took less then 21Hrs. Is there a way to see the printing time after the is done?
bearer last edited by
you can run a simulation on the same file to get an accurate number (would also work before printing). Might take a few minutes on a large print though.
@bearer great thanks I will try.
1ri last edited by
The printing time appears in “enventlog.txt” if you have it activated whit M929 P"eventlog.txt" S1
@1ri I put this M code in the config or in each gcode?
DIY-O-Sphere last edited by
Put it in the config.g