printing time and data.

[Ladusse]

Recently I start a print and my slicer told me arround 21Hrs, I know that is not the right time, it took less then 21Hrs. Is there a way to see the printing time after the is done?

[A Former User]

you can run a simulation on the same file to get an accurate number (would also work before printing). Might take a few minutes on a large print though.

[Ladusse]

@bearer great thanks I will try.

[1ri]

The printing time appears in “enventlog.txt” if you have it activated whit M929 P"eventlog.txt" S1

[Ladusse]

@1ri I put this M code in the config or in each gcode?

[DIY-O-Sphere]

@Ladusse
Put it in the config.g