Babysteps and first layer
-
you need to adjust the Z offset in M558
Owns various duet boards and is the main wiki maintainer for the Teamgloomy LPC/STM32 port of RRF. Assume I'm running whatever the latest beta/stable build is
-
adjust the z offset of the G31 command with the babystepping value
-
still the same i tried both ways
-
@sankafola
If your G31 = Z-0.15 You need to add 1mm to your M665 H as Z0 should be just touching the bed not the paper if you send G1 Z0.1 then it should touch the paper just -
@Carlo i will do that
-
@jay_s_uk correction to my post its a SKR 1.4 turbo and am not using the MOD pin
@Carlo said in Babysteps and first layer:
G1 Z0.1
@Carlo M665 where in config.g or the over ride
-
I don't use an override file for a delta you using a smart effector ?
-
@Carlo yes i do
-
after you adjust the offset of G31 you need to run delta calibration again and save the values in your config
-
The way I do it when I've needed to, is set the height M665 H before I calibrate so when you do G1 Z0.1 it goes to 0.1 with the bed at 60c
I save all the setings from the M500 override file in the config.g stuff like radius etc I leave endstops to calibration so 0.00 in config.g but I set the height 1st then set my trigger height
aagain at 60c bed calibration I do hotend 130c bed 60c and it just works doing it like that
once I'm happy with calibration I do a G29 but I delete the override file and don't have M501 in my config.g and until your setup is correct an override is I believe useless.
Hope this helps
