Temperature rising much more slowly than the expected 1.3°C/sec?
Hi guys. Maestro 3.30 firmware.
I had a big heat bed plate about 330x330 and 5mm thick. I work out of my heated shed but it can get a little colder inside this time of the year. I keep get this error.
Error: Heater 0 fault: temperature rising much more slowly than the expected 1.3°C/sec
How can i get around this? It a big thick plate so I do understand the it take longer to heat up!
PID tune the bed.
Are you sure it's 3.3 firmware?
@Phaedrux PID tune. OK. How do I do that? Any tutorials around?
Sure you bet.
@Phaedrux Thanks brother, that is exactly what I've been looking for. Stay safe man!!