@dc42 Thanks brother!!

@dc42 Thanks brother!!

Presently running a Maestro on 12 volts. Looking to replace the present 1.8 degree stepper motors with 0.9 degree motors. I do know that the board does have a max amp current of 1.68amps. What should I be looking for when it comes to voltage? There are so many different stepper motors voltages to choose from.

Thanks guys

@Phaedrux can do!!

I'm going to reinstall everything to factory setting later today. Format the card and do a fresh install.

Not that I can see. And I have been watching the board temp, its doesn't go above 35-40c, and i do have fans directed to the steppers.

Supply voltage: min 0.0, current 12.2, max 12.3, under voltage events: 0, over voltage events: 0, power good: yes
Driver 0: position 0, standstill, read errors 0, write errors 1, ifcnt 67, reads 58841, writes 6, timeouts 0, DMA errors 0
Driver 1: position 0, standstill, read errors 0, write errors 1, ifcnt 67, reads 58841, writes 6, timeouts 0, DMA errors 0
Driver 2: position 0, standstill, read errors 0, write errors 1, ifcnt 67, reads 58841, writes 6, timeouts 0, DMA errors 0
Driver 3: position 0, standstill, read errors 0, write errors 1, ifcnt 69, reads 58841, writes 6, timeouts 0, DMA errors 0
Driver 4: position 0, standstill, read errors 0, write errors 1, ifcnt 62, reads 58841, writes 6, timeouts 0, DMA errors 0

Write errors1??? What does this mean in english?!

Morning peeps.

I have had this issue for a few weeks now, my Maestro 3.1.1 stops part way threw a print. Is there a log file that I can look at to see there are errors? I checked in the "Console" but no errors are showing in there. It seems to be with larger print files. I'm using Simplify3D as my slicer, never had issues with it before. Yesterday I changed the MicroSD card, formatted and copied the files over and it still happened. Checked all the cables to make sure nothing was loose. Any ideas?

@Phaedrux Thanks brother, that is exactly what I've been looking for. Stay safe man!!

@Phaedrux PID tune. OK. How do I do that? Any tutorials around?

Sorry 3.1.1